garage door sensor
I suspect I have a bad sensor on one side of the garage. Everything has worked like a champ until this morning.
One sensor has a green light, the other red. If I break the energy beam, both sensors blink red. Since the one sensor can 'see' the other, I assume the alignment is good. adjusting the position of each fails to put the sensor into a green state. I don't see any reboot switch on either sensor to see if I can reset it.
Never dealt with these fellers, but I'm leaning towards dropping by the Depot and getting a replacement set. Or is there a trick?
__________________
e^(i * pi) + 1 = 0
5 great numbers in one little equation.
|